Author Topic: Gauge package harness at fuse panel  (Read 631 times)

0 Members and 1 Guest are viewing this topic.

Offline macdude443

  • Eagle DL
  • ***
  • Posts: 201
  • Thumbs Up 11
Gauge package harness at fuse panel
« on: May 13, 2013, 05:33:45 PM »
I got a wiring harness for the center gauge cluster, but I can't remember where to connect the fuse panel ends.  Can someone with a gauge package post a picture of their fuse panel?

Offline macdude443

  • Eagle DL
  • ***
  • Posts: 201
  • Thumbs Up 11
Re: Gauge package harness at fuse panel
« Reply #1 on: May 13, 2013, 07:07:10 PM »
These are the connectors for the fuse panel I can't remember.  The black connector goes to the tach.



Here are 2 of the 3 lines in the engine compartment (ground not shown).  The bare one went to the coil I believe (black w/tr).  The other line with the connector I'm not sure about (black).  Would this be the oil pressure sending unit?

If I don't have a coil (put in an HEI), where would the coil wire go now?

« Last Edit: May 13, 2013, 07:09:16 PM by macdude443 »

Offline ammachine390

  • Eagle Limited
  • *****
  • Posts: 704
  • Thumbs Up 41
Re: Gauge package harness at fuse panel
« Reply #2 on: May 13, 2013, 08:23:47 PM »
If I don't have a coil (put in an HEI), where would the coil wire go now?

On the HEI distributor, there should be two connectors, one for switched battery positive, and the other is for a tach connection.
Dan
1981 AMC Concord DL 258 Auto

Click for Villa_Park, IL Forecast" border="0" height="100" width="150

 

Vacuum Gauge in center console

Started by drock87

Replies: 18
Views: 3000
Last post March 02, 2012, 12:24:18 AM
by carnuck
Console gauge wiring

Started by macdude443

Replies: 0
Views: 499
Last post September 06, 2012, 11:13:18 PM
by macdude443
now the fuel gauge

Started by sportpig

Replies: 8
Views: 593
Last post June 15, 2013, 03:35:50 PM
by sportpig
secondary fuse box power source question

Started by demonicdragon

Replies: 12
Views: 1438
Last post May 03, 2011, 10:07:28 PM
by eaglefreek
looking for a single prong Fuse add a line

Started by demonicdragon

Replies: 2
Views: 705
Last post June 15, 2011, 08:40:39 PM
by demonicdragon